MARUKIN" Standard Thick Chisel Shirogami no.2 steel, 3mm~24mm

Specification

■ Size: Blade length approx. 85mm, neck length approx. 85mm, handle approx. 125mm

■ Material: Shirogami No. 2 steel + extra soft iron

■ Pattern: Red oak pattern

■ Use: Mainly used for processing structural materials

■ Features:
This is our most standard professional chisel. The blade is handmade using Shirogami No.2 steel.
It can be used by many people, from the general public to professionals.

■ Note:
The down ring needs to be sunk.
The wooden handle is made of natural materials, so the color of the actual product may differ from that shown in the photo.

Need Setting Up Katsura before to use

About the Katsura (Ferrule) on Japanese Chisels
Japanese chisels have a steel ring called a katsura on the end of the wooden handle.
Before using the chisel for the first time, the katsura needs to be prepared.
This helps prevent the handle from cracking and makes the tool safer and longer‑lasting.

Before using a chisel, lower the ferrule attached to the end of the handle slightly below the handle, then tap the end of the handle with a hammer to widen it, being careful not to hit the ferrule itself.

That's where this downward-facing ring striker comes in handy. Its inner surface cone-shaped, and when you place it over the handle and strike straight, without striking the handle, force is applied to the surrounding descending wheel, allowing only the descending wheel to move down easily.

For chisels 4 bu (≈12 mm) and larger, place a piece of soft wood underneath, stand the chisel upright on it, place the hoop‑setting tool over the handle, and strike downward. Do not hit hard all at once—tap gradually while checking the progress.

For chisels 3 bu (≈9 mm) and smaller, do not place wood underneath. Hold the chisel in the air, align the hoop‑setting tool straight with the handle, and tap gently. Narrow and thin chisels may bend from the thinner neck section, so proceed carefully.

When using a narrow, thin chisel, be careful as it may bend at the thin part of the shaft.

Chisel Hoop Setting Tool

■ Blade width:

3mm
Item no. 1110979

6mm
Item no. 1110980

9mm
Item no. 1110981

12mm
Item no. 1110982

15mm
Item no. 1110983

18mm
Item no. 1110984

21mm
Item no. 1110985

24mm
Item no. 1110986

Import duties; taxes and charges are not included in the item price or shipping charges. These charges are the buyer's responsibility.